|
|
|
|
|
|
|
|
|
|
|
Fills opening in covers if twistout is removed in error. QOFPCP are used only in QO load centers, filling the spaces where no circuit is attached. CHOMFPCP are for use only in Homeline load centers. UL Listed and ANSI Certified.
|
Fills opening in covers if twistout is removed in error. QOFPCP are used only in QO load centers, filling the spaces where no circuit is attached. CHOMFPCP are for use only in Homeline load centers. UL Listed and ANSI Certified.
|
Filler plate for Stab-lok Federal Pioneer circuit breakers. For use in present design of Stab-lok enclosures, except 400A. Will also fit previous design using 1/2" metal KO's. Consists of 1 strip of 4 - 1/2" plastic fillers suitable for 4 NC poles or 2 NA poles. CSA approved.
|
|
|
|
|
|
|
|
|
|
|
|
|
Non-Fusible Air Conditioner Disconnect. 60 amp A/C disconnect switch. Large enclosure allows for ample wiring space. Manufactured with powder coated G90 galvanized steel for fade, scratch, and corrosion resistance. 6 knockouts with 1/2 " , 3/4 " , and 1 "
|
|
Square D Safety Switch, 120/240 VAC, 30 A, 2 Pole, 100 kA Short Circuit, Surface Mounting, NEMA 1 NEMA Rating, 3.63 in Length, 7-1/4 in Width, 9-1/4 in Height
|
|
|
|
|
|
|
|
|
|
|
|
|
4/8 circuit 100 amp loadcentre. Capacity: 4 full mode circuits ( 1 " ) or 8 half mode circuits ( 1/2 " ). Combination mount. 1 phase; 3 wire 240V AC max.
|
NON-COMBINATIONS Main lugs/non-combination indoor. 1 phase, 3 wire. 120/240V AC, 10,000 A/C. 1 per carton. (Uses QO breaker from Square D). For use in garages or any other out buildings requiring a separate panel such as pool sheds. Panel would be fed from a feeder breaker in the main entrance panel in the house.
|
Main lug indoor load center, 70 amp, 2 spaces/4 circuits. Maximum SCCR of 10,000 and a maximum load of 240 volts. NEMA type 1 enclosure. Expandable loadcentre capacity with the use of tandem or quad breakers. CSA approved for vertical, horizontal or inverted mounting. Accepts aluminum or copper conductors. Approved to only accept Canadian HomeLine breakers.
|
|
|
|
|
|
|
|
|
|
|
|
|
2/4 circuit 60 amp loadcentre. Capacity: 2 full mode circuits ( 1 " ) or 4 half mode circuits ( 1/2 " )Surface mount. 1 phase; 3 wire 240V AC max
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Siemens Safety Switch, General-Duty, 120/240 VAC, 30 A, 1 ph, HP Rating: 1/2 hp, 2 Pole, 10 kA Short Circuit, Lug Terminal, 2 Wires, Padlock-Off Actuator, -20 to 120 deg F Operating, NEMA 1 NEMA Rating, Steel Enclosure, 5-1/2 in Width, 8-1/4 in Height
|
Main lug indoor load center, 100 amp, 6 space/12 circuit. NEMA type 1 enclosure. Single phase, 3 wire, solid neutral. Expandable loadcentre capacity with the use of tandem or quad breakers. CSA approved for vertical, horizontal or inverted mounting. Accepts aluminum or copper conductors. Approved to only accept Canadian HomeLine breakers.
|
|
|
|
|
|
|
|
|
|
|
|
|
Used as an add-on load center, connected to the service entrance loadcentre when spaces for more circuits are needed. Expandable loadcentre capacity with the use of tandem breakers. CSA approved for vertical, horizontal or inverted mounting. Accepts aluminum or copper conductors. Approved to only accept Canadian Square D QO breakers.
|
NON-COMBINATIONS Main lugs/non-combination indoor. 1 phase, 3 wire. 120/240V AC, 10,000 A/C. 1 per carton. (Uses QO breaker from Square D). For use in garages or any other out buildings requiring a separate panel such as pool sheds. Panel would be fed from a feeder breaker in the main entrance panel in the house.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
60 amp Homeline main breaker loadcentre with 12 spaces, 24 circuits maximum. Each is equipped with a factory installed main circuit breaker, which serves as the main disconnect to turn off power to the loadcentre, as well as to protect the load center from an overload or short circuit. Dimension: 17.92 H x 14.25 W x 3.75 D.
|
Used as an add-on load center, connected to the service entrance loadcentre when spaces for more circuits are needed. Expandable loadcentre capacity with the use of tandem breakers. CSA approved for vertical, horizontal or inverted mounting. Accepts aluminum or copper conductors. Approved to only accept Canadian Square D QO breakers.
|
NON-COMBINATIONS Main lugs/non-combination indoor. 1 phase, 3 wire. 120/240V AC, 10,000 A/C. 1 per carton. (Uses QO breaker from Square D). For use in garages or any other out buildings requiring a separate panel such as pool sheds. Panel would be fed from a feeder breaker in the main entrance panel in the house.
|
|
|
|
|
|
|
|
|
|
|
|
|
60 amp QO main breaker only loadcentre with 16 spaces, 32 circuits maximum. Dimension: 18 H x 14.25 W x 3.75 D
|
4/8 circuit 100 amp loadcentre. Capacity: 4 full mode circuits ( 1 " ) or 8 half mode circuits ( 1/2 " ). Combination mount. 1 phase; 3 wire 240V AC max.
|
Used as an add-on load center, connected to the service entrance loadcentre when spaces for more circuits are needed. Expandable loadcentre capacity with the use of tandem breakers. CSA approved for vertical, horizontal or inverted mounting. Accepts aluminum or copper conductors. Approved to only accept Canadian Square D QO breakers.
|
|
|
|
|
|
|
|
|
|
|
|
|
COMBINATION Ideal for use as Service Entrance Panel. 1 phase, 3 wire. Main breaker compartment can be sealed. Main breaker can be locked. Main wire size CV/AL #4-2/0. NOTE: Main Breaker is included.
|
100 amp QO main breaker only loadcentre with 16 spaces, 32 circuits maximum. Dimension: 18 H x 14.25 W x 3.75 D
|
Spa panel. 4/8 circuits. 1 phase. 3 wires. 120/240v. 125a
|
|
|
|
|
|
|
|
|
|
|
|
|
Homeline Load Center, Series: CHOM, 120/240 VAC, 125 A, 1 Phases, 3-Wire Wiring, 10 kA Interrupt, Main Lug Circuit Breaker, Plug-In, 8 Spaces, 16 Circuits, 6 - 2/0 AWG Cu/Al Cable, Overhead/Underground Feed, Flush Adjusting Cover, Aluminum Buss Bar, NEMA 1 Indoor Enclosure, 17.92 in Overall Height, 14-1/4 in Overall Width, 3-3/4 in Overall Depth
|
4/8 circuit 100 amp loadcentre. Capacity: 4 full mode circuits ( 1 " ) or 8 half mode circuits ( 1/2 " ). Combination mount. 1 phase; 3 wire 240V AC max.
|
Combines a service entrance loadcentre with a selection of breakers. Designed to accept the plug-on (pigtail less) combination arc fault circuit breakers. Circuit breakers connect directly to the neutral bar of the loadcentre, eliminating the need to attached a separate neutral wire to the neutral bar. Fully distributed neutral bar accepts either pigtail or pigtail less arc fault breaker or ground fault breaker.
|
|